Productos

Lightweight and portable

Works with only 10 µ L of total blood (capillary and venous blood)

Strips for PT, APTT and COMBO (PT and APTT sets)

Correlation with classical PT and recombinant thromboplastin reference reagents.

PT results in less than 2 minutes

APTT results in a maximum of 7 minutes (same time COMBO)

No need to calibrate.

Internal Quality Control

Microfluidics technology with electro-Conductimétrica reading

Excellent correlation between different lots.

Barcode Reader

Communication with LIS software

Storage up to 200 results

Puncture case and pen included

Fully automated instrument for biochemical analysis of urine by means of test strips

Reading performed by colorimetric photometry, dispensing the exact amount of urine in each reagent of the strip

Density (SG) measured by a refractometer

Turbidity measured by a turbidimeter

Color measured by an RGB sensor

It incorporates a program of urgent samples

Individual homogenization of samples

It allows the use of different types of test strips

Strips of 10 parameters: Urobilinogen, Bilirubin, Red blood cells / Hemoglobin, Ketone, Leukocytes, Proteins, Nitrites, Ph, Glucose.

Stripes of 13 parameters: It is the same of 10 parameters plus Microalbumin, Creatinine and Vitamin C.

Performs the calculation by color of the reagents of the Microalbumin / Creatinine Quotient

Touch screen for easy and intuitive communication with the user. Software in Spanish.

Quality control program

Incorporates Barcode for samples

Speed ​​of 240 test / hour

Ion analyzer with selective electrode. Tests available: Na, K, Cl, Ca and pH

The instrument performs the determination of ions in less than one minute in serum, plasma or blood.

The required sample volume is 100 microliters.

Simple and intuitive menu in Castilian.

Internal printer

Automatic or on-demand calibration.

Specific program for veterinary measurement. Automatic washing of the sample probe. Reagents for determinations are included in a single, easy-to-use and replacement kit. Simple and fast maintenance thanks to its modular design. You can optionally connect an automatic sampler.

Chemiluminescence system

Models 600, 800, 100, 2000 and 2000+

“FLASH” methodology Chemiluminescences.

Possibility to place more than one reagent of the same technique.

Integral reagents with calipers and built-in controls.

Identification of reagents by RFID (radio frequency) avoiding possible errors with bar codes.

Direct entry by RFID of master curve, batch, expiration and no. test of the technique to be performed.

Continuous uninterrupted workload for samples and reagents.

Optimization of the work process of the laboratory and the staff dedicated to its realization.

Work by RANDOM mode (samples) or batch (methods)

Versatility and adaptability.

Recalibration of the techniques to 2 points.

Emergency tests.

First result between 17 and 40 minutes.

Two-way Host-query communication

More than 100 methods available.

Interactive software with touch screen.

15-position Multibucket reading. Reading Volume: 500 microliters per Cuvette. It allows the realization of methodical to final point, kinetic, fixed time and differential. The methodologies can be analyzed simultaneously to final point, fixed time and kinetics. Up to 60 methodicals can be programmed. The optical system contains 7 filters between 340 and 670 nm. Thermostatic block for reagent incubation and sample Stirrer for perfect homogenization of reagent and sample.

Adaptable to every photometric method

48 positions of samples, primary tubes or wells

48 reagent positions in bottles of 50, 30, 20 or 5 ml

80 reaction positions, with 0.6 cm optical path cuvettes.

Up to 200 tests per hour.

Minimum water consumption (1 liter/500 test).

PC Management program with unlimited possibilities of programming methods, quality control, patient files, personalized reports, bidirectional communication with Host

Can analyze samples up to 0.1 ml

200 ul of total volume are sufficient for reading

Reading by Microcuvette of flow or by single-use cuvettes. Reading Volume: 400 – 1000 microliters. It allows the realization of methodical to final point, kinetic, fixed time and differential. Up to 100 methodicals can be programmed. The optical system contains 7 filters between 340 and 670 nm. Thermostatic block for incubation of up to 10 cuvettes. incorporates internal printer.

RAL introduces the new line of NG Biotech rapid tests for antibiotic resistance detection.

Antibiotic resistance

The problem of bacterial resistance to antibiotics is a cause of concern in recent years, especially in Spain. 700,000 people die every year in the world and 25,000 in Europe because of these resistances. The Directorate-General for Health of the European Union recommends the preparation of action plans against these resistances.

Because of this, rapid detection of resistance and characterization are essential to combat resistant bacteria, administer appropriate therapy, prevent new infections, improve health systems and optimize health budgets.

NG Biotech has worked to develop a new generation of multiplex rapid tests based on the use of monoclonal antibodies. These tests detect enzymes secreted by bacteria that reflect their resistance profile.

Available tests

NG-Test CTX-M: Detection of bacteria resistant to lactams antibiotics. Mainly Gram-negative bacilli.

NG-Test Carba: Detection of bacteria resistant to carbapanémicos antibiotics. Detects the Carbapanemasas. The analytes detected are: NDM-1, OXA-48, KPC, VIM-1, VIM-2, IMP-1 and IMP-2.

In this case it is a multiplex test. Different analytes are detected independently. A Test line appears (if positive) for KPC, OXA, VIM, IMP and NDM, in addition to the control line

NG-Test MCR: Detection of bacteria resistant to colistin. Detects the MCR-1 analyte.

High sensitivity for the determination of the essential tests of the plasma phase of hemostasis (PT, PTT, TT, fibrinogen, factors etc.). Turbo-Densidométrico system of clot detection, electronic time control with precision of 0.1 seconds and with electronic thermostat at 37 ° C. Its exclusive basic operating principle (constant zeroing of DO) allows the use of any type of reagent, since the initial transmission differences are automatically compensated. It also detects variations in positive and negative, thus facilitating detections at very low concentrations (FIBRINOGENO even at 40 mg/100 ml). Memory capacity for 10 techniques. Performs calculations automatically based on memorized calibration curves with their respective units.

High sensitivity for the determination of the essential tests of the plasma phase of hemostasis (PT, PTT, fibrinogen, factors etc.). Turbo-Densidométrico system of clot detection, electronic time control with precision of 0.1 seconds and with electronic thermostat at 37 ° C. Its exclusive basic operating principle (constant zeroing of DO) allows the use of any type of reagent, since the initial transmission differences are automatically compensated. It also detects variations in positive and negative, thus facilitating detections at very low concentrations (FIBRINOGENO even at 40 mg/100 ml). Memory capacity for 10 techniques. Performs calculations automatically based on memorized calibration curves with their respective units.

Working procedure in 3 simple steps. Multiple test parameters with high performance: 28 parameters in Colorimetry and 3 parameters in electrolytes. 128 tests/hour. Easy to use with the touch panel. It does not require pre-treatment of the sample. Only 10 Μ l/test. Automatic dilution. No calibration Required. QC card System. Accurate and reliable results in long-term testing.

Quantitative Immunofluorescence Analyzer It has an ample catalogue of plates to carry out tests of NT-NTPROBNP, D-dimer, PCT, troponin, HS-CRP, HbA1c, CK-MB, CysC, mAlb, NGAL, B2-MG and tests combo Serum, plasma, total blood, or urine samples may be used Quantitative reading in 2-15 minutes Possibility of sample positive identification using barcode reader QR code reader for test identification Automatic calibration Large-size touch screen for easy program handling Integrated printer

33 Parameters Hematological AutoAnalyzer

Up to 90 results per hour

Dynahelix flow technology for accurate particle count

Laser Dynascatter technology for optimal WBC differentiation

Reduced sample Volume (40 ul venous blood, 20 ul capillary blood)

Balancing homogenization

7 Racks Continuous Load

Racks identified by bar code and color

File of 10.000 patients

Quality Control Program (Levey-Jennings, Westgard, XB)

10.4 inch touch screen

Automatic system of clinical chemistry analysis by rotors

Works with only 100 µ L of total blood, plasma or serum

Wide range of rotors that allow analyzing from 5 to 17 analysis parameters

Available parameters: Albumin, ALP, amylase, direct bilirubin, total bilirubin, calcium, ck, CK-MB, chlorides, cholesterol, HDL, LDL, CO2, creatinine, globulin, glucose, GOT, GPT, HBDH, phosphate, LDH, magnesium, potassium, total protein, sodium, Triglycerides, Urea, Alb/Glob

Three-Step analysis: Dispense sample and diluent, insert rotor into the instrument and read results

Auto-Calibration by QR code

Results in 7-12 minutes

Compact and portable system (2.5 kg, 17.5 * 12.5 * 21 cm)

Stores up to 50,000 results

Complete standardization, traceability and reproducibility of the stains.

Working cycles of 10 samples with load capacity of 20 samples.

Completely closed machine with active carbon filter for the complete elimination of toxic vapors.

Wide portfolio of high quality reagents (Gram-Hücker, Gram-Nicole, Fluo RAL/Auramina, Cold Zn, 555/GIEMSA).

Radiofrequency-controlled reagents (RFID).

Immersion staining system.

Reagent level Sensor.

Minimum maintenance.

Minimum generation of liquid waste (11 ml per slide)

Electrophoresis Reader for cellulose acetate plates. Designed to perform electrophoresis of Seroproteínas, lipoproteins and hemoglobin. The instrument reads, calculates, and prints separate protein fractions. Results obtained in 30 seconds. Printing results in percentage and absolute value. Minors can be introduced, changed or eliminated and the value of albumin corrected according to the colouring affinity used in staining.

The SRA-48 is an automatic analyzer for measuring the speed of rate (modified Westergreen). Using vacuum tubes (also can be used without vacuum) of easy use to avoid any type of interference. The unit can read 48 tubes simultaneously, or make sequential readings and go loading and unloading the tubes in several series during the process. Designed and controlled by a group of expert researchers in this field. The MIX-48 is a “rotary mixer” for use in conjunction with the SRA-48. The tube with the blood sample is mixed with the special citrate to avoid clots, foam, or any other interference.